Tempo RAID133
Please click the arrow next to the category to expand or collapse:
Driver (1)
IDDownload TitleDownload LinkPost Date
437 Deep Sleep Support (OS X 10.2) 1.5.2Aug-07-2009
 
Firmware (2)
IDDownload TitleDownload LinkPost Date
442 Tempo RAID133 Firmware Updater (Mac OS 8.1-9.2) 2.4.5Aug-07-2009
Operating System Requirements: Mac OS 8.1-9.2
Description: This software updates the ROM (firmware) on the Sonnet Tempo RAID133 PCI adapter card to version 2.4.5. This update adds support for long Ultra ATA cables.
Note 1: ***IMPORTANT*** Before running the updater, you MUST read the Read Me file to ensure a successful ROM (firmware) update.
Note 2: Before proceeding with the firmware update, you must ensure your system is NOT booted in Mac OS X; do not attempt to run this in Mac OS X Classic mode. This software will only function in Mac OS 8.1 through OS 9.2.
 
443 Tempo RAID133 Firmware Updater (OS X)May-08-19
 
Manual (1)
FAQ (2)
IDArticle TitlePost Date
165 Tempo SATA or Tempo SATA RAID133 won't boot from Mac OS 9.x when it is installed in a partition greater than 190GB.Apr-25-10
167 Disk space reported under Mac OS X is less than reported under Mac OS 9.x.May-07-09
Mac OS X, Version 10.0 through 10.1.5 does not support the 48-bit addressing utilized by hard drives with capacities greater than 137GB, but Mac OS 9.x does. As a result, Mac OS 9.x accurately reports disk space on these drives, but Mac OS X, Version 10.0 through 10.1.5 does not; these OS versions report a maximum of 128GB of disk space. Because of this lack of support, data corruption may occur on these high capacity drives. This problem can occur on any computer running Mac OS X, Version 10.0 through 10.1.5 with Tempo RAID133 installed and a hard drive with a capacity greater than 137GB.

To correct this issue, install the drivers for large drive support that are included in Mac OS X, Version 10.2 through 10.2.x; upgrading from an earlier version of OS X to Mac OS X, Version 10.2.x will alleviate this issue.