| ID | | Article Title | Post Date |
|
36 | 
| What are the benefits of supporting Spread Spectrum Clocking (SSC)? | Mar-02-10 |
|
37 |
| Is it possible to boot from a volume that resides on the Tempo SATA card? | Mar-02-10 |
|
39 |
| Can I hot-swap a disk drive that is attached to any Sonnet Tempo Serial ATA card? | Mar-23-10 |
|
40 |
| How does hot-swap functionality work? | Mar-02-10 |
|
63 |
| Can I operate two Tempo SATA cards in the same system? | Sep-02-09 |
|
106 | 
| Is Tempo SATA E4P, E4i, X4P, or X4i compatible with Red Hat Linux? | Sep-02-09 |
| Tempo SATA E4P, E4i, X4P, and X4i are supported under Red Hat Enterprise 4 Linux with Marvell (TSATAII chip set) drivers. The Marvell Linux driver supports direct connect drives but not port multipliers, so there is no compatibility with the Fusion D4Q, Fusion D5P, Fusion R4Q and Fusion R4P storage systems. As in Windows, drives must be connected at boot time. |
| |
|
120 |
| How do I set up a RAID 0 striped array under Windows XP Professional or Vista? | Mar-23-10 |
|
121 |
| Can I set up a RAID 1 mirrored array under Windows XP or Vista? | Mar-23-10 |
|
165 |
| Tempo SATA or Tempo SATA RAID133 won't boot from Mac OS 9.x when it is installed in a partition greater than 190GB. | Apr-25-10 |
|
193 |
| Is target disk mode supported on TSATA? | May-12-09 |
| Althought the TSATA supports booting from an attached drive, it does not support target disk mode when booting from an attached drive. Try connecting the two computers via ethernet to exchange files. |
| |
|
206 |
| The Tempo SATA card does not seem to work properly in my Power Mac G4. Do I need different firmware? | Apr-25-10 |
|
207 |
| Why can't I install Mac OS X 10.5 (Leopard) on a drive attached to the Tempo SATA card? | May-12-09 |
|
757 |
| My Stardom RAIDSonic ST3620-2S-S2 is not reliable with 6Gb drives and and a 6Gb controller. | Jul-08-13 |
| The Stardom RAIDSONIC ST3620-2S-S2 is not reliable when connected at 6Gb. It was designed for 3Gb SATA. If you connected previously using a 3Gb controller, even with 6Gb drives, the connection was 3Gb. With the 6Gb controllers and 6Gb drives, the connection is negotiated at 6Gb, but the connection is not reliable because of the older design of the Stardom chassis does not support 6Gb. The drives may not be recognized or if recognized, transfers will fail at some point. |
| |
| |
