| In previous versions of the Crescendo/7200 enabler software, Sonnet was required to create specific "patches" for each PCI card supported. Whenever the firmware of a PCI card was updated, the 7200 enabler software required a version revision as well.
To address compatibility issues, upgrade the version of the 7200 enabler you are running on the machine to version 1.1 (or later) of the enabler software. In this new version an entirely new algorithm has been developed for recognizing PCI cards from the processor running on the PCI bus. This new breakthrough vastly expands compatibility to virtually all PCI cards. Also with the 1.1 release, PCI cards can be used in almost any combination, and utilize any and all available slots. It is still recommended that the Crescendo/7200 card occupy slot 1.
To update to version 1.1, remove the 7200 upgrade processor and boot the computer. Then download the Crescendo/7200 software. Once downloaded, run through the installation. The installer will remove any old version of the enabler that is currently installed and install version 1.1. When the installer is done, shut the computer down, reinsert the 7200 upgrade processor, and boot the computer normally. |
