| ID | | Article Title | Post Date |
|
27 | 
| How can I distinguish between the earlier Tempo-X eSATA (4+4 and 8e) products supporting 3 Gigabit/sec speeds and the older cards that support 1.5 Gigabit/sec speeds? | May-07-09 |
|
36 |
| What are the benefits of supporting Spread Spectrum Clocking (SSC)? | Mar-02-10 |
|
37 |
| Is it possible to boot from a volume that resides on the Tempo SATA card? | Mar-02-10 |
|
39 |
| Can I hot-swap a disk drive that is attached to any Sonnet Tempo Serial ATA card? | Mar-23-10 |
|
42 | 
| Can the Tempo SATA cards co-exist with other manufacturers' Serial ATA cards? | Oct-27-09 |
| Often, yes. Sometimes, not. Some other manufacturers' drivers may incorrectly assume a Sonnet card is their SATA card which may cause havoc. The symptoms include significantly slower performance, driver not loading, or both drivers loading and causing and kernel panics as they both try to access the same card. Sonnet recommends removing other manufacturer's card(s) and driver(s) if a problem of this type occurs. |
| |
|
44 |
| How can I distinguish between the earlier Tempo-X eSATA products supporting 3 Gigabit speeds and the older cards that supported 1.5 Gb speeds? | May-07-09 |
|
63 |
| Can I operate two Tempo SATA cards in the same system? | Sep-02-09 |
|
67 |
| What kind of performance can I expect from a using a Sonnet Tempo SATA Card in a PCI slot (like in a Power Mac G4)? | Oct-12-09 |
|
174 |
| Drive(s) connected to the Tempo-X SATA 4+4 occasionally do not appear when the computer is booted or an error message regarding the RAID array connected to the Tempo-X SATA 4+4 is occasionally displayed at boot up, and the RAID array cannot be used. | May-07-09 |
| A very small number of Tempo-X SATA 4+4 users have reported a condition in which connected drives installed in an external case intermittently do not appear when their computer is booted.
To address this issue, update the Tempo-X SATA 4+4 card's firmware to version 1.0.1 or later by downloading and running the latest Tempo-X firmware updater. |
| |
|
219 |
| With a Tempo-X SATA host controller installed and drives connected, the computer locks up and will not respond to keyboard or mouse input, and must be forced to power off (press and hold the power button for more than 5 seconds) then restarted. | May-07-09 |
|
220 |
| Multiple Hitachi hard drives connected to a Tempo-X SATA host controller are not always detected (won't mount). | May-07-09 |
|
404 |
| The Sonnet Tempo SATA card does not work with my Western Digital My Book Premium ES Edition, or Seagate Technology FreeAgent Pro. | Mar-02-10 |
|
452 |
| I upgraded my Tempo SATA software in a PowerMac G4 or G5 and the card is giving a lot of system errors. | Oct-12-09 |
|
454 |
| I have connected a large hardware RAID volume (for example, a 4TB Fusion D400QR5) to a Sonnet Pro SATA card in a Macintosh, and it is showing up as only 2TB. Why? | Oct-14-09 |
|
459 |
| The performance of my drive array is significantly less than I expect. | Jun-14-11 |
|
544 |
| How do I uninstall the Sonnet Pro SATA Driver? | Dec-26-10 |
| |
