Operating System Requirements: Windows 10 (64-bit), Windows 11 Description: SxS UDF Driver software enables reading of MXF files recorded in UDF mode on SxS memory card. [Note: This driver is not sufficient to support the computer communicating with the device. You must also install the SxS Device Driver.] Installation of these drivers enables the Sonnet SF3 Series SxS PRO X Card Reader, SF3 Series SxS Pro Card Reader, SxS PRO X Thunderbolt 3 Single Slot Reader, Echo ExpressCard Thunderbolt Adapter, Qio, and Qio E3. to support UDF files.
Download and install the latest UDF driver, and then restart your computer.
Mac OS 10.7.5 will not mount FAT32 volumes connected to the eSATA ports of this device. (FAT32 volumes mount fine in 10.6.8 and in 10.8.2 and later.)
As a workaround, you can manually mount volumes with the following procedure:
1) Open terminal (Applications > Utilities > Terminal)
2) Run the following command: diskutil list
Look for the target volume in the IDENTIFIER column. The volume will have a name like disk4s2.
3) Create a mount point by using the following terminal command: mkdir /Volumes/myvolume
Note: myvolume is the name of the mount point you will create and must be unique - for example, you cannot mkdir /Volumes/FAT if a volume named FAT is already mounted.
4) Mount the target volume with the command: sudo mount -t msdos /dev/disk4s2 /Volumes/myvolume
Note: disk4s2 is the from the IDENTIFIER column from step 2. myvolume is the unique name you chose in step 3.
The volume should now be mounted and is available for use. The volume must also be unmounted through terminal - finder will not be able to unmount the volume.
The command to unmount the volume is: sudo umount /Volumes/myvolume
where myvolume is the mount point you created in step 3.
